REDCAT Lightspeed Bedienungsanleitung PDF herunterladen (Seite 23)

REDCAT User Manual

19 | REDCAT User Manual

3. Slip the REDMIKE with lanyard around the neck

and position the top of the microphone just below

the collarbone. NOTE: Positioning of the REDMIKE is

critical for proper volume adjustment.

While speaking in a normal voice slowly increase the

volume of the corresponding channel on the REDCAT

until your voice is barely audible. REMEMBER:

This equipment supplements user’s voice so they

are able to speak in a conversational tone. Having

the volume set too high will result in feedback and

listener fatigue.

INITIAL SET-UP: REDMIKE

SPEAKER OUTPUTS

250 400

700

1K 1K4

2K5

+10

-10

OFF

ON ON

VOL.

ADJ.

ALD OUT

AUX OUT

VOL.

ADJ.

COMPUTER

AUDIO INPUTS

TV/VCR CD/DVD

800iX

INPUT

PAGING INPUT

ADJ

DC POWER CHARGERS

24VDC

L L R R

SENSOR INPUTS

SENSOR

SHORT

1 2 3

5. Once initial volume level is set, walk

around the room and listen for audio

dropout and overall audio quality.

Fine-tuning the audio is accomplished by

making minor adjustments to the 8-Band

Graphic Equalizer on the back panel of

the REDCAT.

See page 4 for hints on setting the EQ.

1. Turn the REDCAT switch to the ON

position. The RED LED on the switch

will glow.

2. Turn on the REDMIKE. The CH A/B GREEN LED on

the REDCAT will light to indicate an IR signal is being

received.

6. If a second REDMIKE was

purchased, repeat steps 2-4.

NOTE: Each REDMIKE has its

Channel pre-set to either A or

B. No further adjustment is

necessary.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare

REDCAT Lightspeed Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern